Modeling in Alias

Since Sketchup has its limit, i decide to rebuild my model in another different program that would give better quality then Sketchup. It is called Autodesk Alias Automotive, a specialised program in indusrty. It doesn't take me long time to finish the model in Alias.

 First step is to insert picture that has been done previously into Alias.

 If i want to insert a picture, i need to create a new canvas first.

 I start creating a circle by using circle tool and then magnify it.

 Create a circle in smaller diamter by using offset tool.

 Copy these circles to the rear wheel.

 Next, i draw the shoulder lines using new CV tool.

 I draw another two lines to create a surface using rail surface tool.

 And then project the shoulder lines i just draw onto this surface.

 Connect the curve on surface and shoulder line by drawing another few CVs.

 Then i use rail surface tool to create a new surface between shoulder line and curve on that surface.

  Then create a new surface using rail tool and project the lower shoulder line onto it.

 Trim the rest of surface.

 I repeat the previous steps to build a surface to fill the gap between the two surface i create earlier.